Water Heat Recovery Units

Sort & Filter
Home Household Essentials Water Heat Recovery Units
Show12243648
Home Household Essentials Water Heat Recovery Units

ThermoDrain drain water heat recovery units capture heat from warm drain water, such as from showers, and use it to preheat the cold water going to your water heater. Choose by efficiency rating, from 42.1% to 57.2%, and by drain size, such as the 4" TD442B-PEX.

See the full ThermoDrain range. These units install vertically in the main drain stack, so installation is usually done by a plumber.

Drain water heat recovery: sizing, efficiency, installation and FAQs ▾

Drain Water Heat Recovery FAQs

How does a drain water heat recovery unit work?

A drain water heat recovery unit is a section of drain pipe wrapped in a fresh-water coil, so warm water going down the drain preheats the cold water headed to your water heater. Natural Resources Canada says the heat passes through the copper wall and the drain water never mixes with the fresh water. ThermoDrain units have no moving parts.

When does a drain water heat recovery unit save the most energy?

A drain water heat recovery unit saves the most energy when warm water is draining while cold water is being drawn at the same time, which Natural Resources Canada says mostly happens with showers. Water that drains after the tap is off, like a bath, gives the unit little to preheat. ThermoDrain describes its units as recovering heat from shower wastewater.

What size drain water heat recovery unit do I need?

Choose a drain water heat recovery unit that matches your drain pipe diameter and fits the straight vertical height available on the drain stack. ThermoDrain says the overall length is 3 inches longer than the nominal length in the model number. PureFilters carries 3-inch models from 33.5 to 61.5 inches nominal, such as the TDX3335B-PEX and TDX3615B-PEX, and the 4-inch TD442B-PEX.

What does the efficiency rating on a drain water heat recovery unit mean?

The efficiency rating on a drain water heat recovery unit is the share of drain water heat it recovers at a standard shower flow of 9.5 L/min (2.5 GPM). Longer units recover more: the ThermoDrain TDX3335B-PEX is 41.02% efficient and the TDX3615B-PEX is 55.04%. Efficiency rises at lower flows, reaching 62.52% for the TDX3615B-PEX at 5.5 L/min.

How should a drain water heat recovery unit be connected to the plumbing?

A drain water heat recovery unit is most efficient in the equal-flow setup, where the preheated water feeds both the water heater and the shower's cold supply. ThermoDrain says feeding only the water heater, or only the shower's cold side, is about 20% less efficient. Equal flow is not allowed in Quebec and is not recommended for showers above 4 GPM (15 L/min).

Can I install a drain water heat recovery unit myself?

A drain water heat recovery unit should be installed by a licensed plumber, and ThermoDrain's instructions call for a licensed professional who follows local codes. The unit must be vertical in the drain stack, out of any spot where it could freeze. Once installed it needs no maintenance beyond checking the inspection holes on the couplings for leaks twice a year.